Catalogue pages 101–104
Multi-point and single-point lock bodies
Lock bodies for inward and outward opening sash and door sets: multi-point bodies with locking points along the faceplate, single-point bodies, and passage bodies without a lock.
What the catalogue covers
The catalogue groups these parts as lock bodies and prints them by faceplate length and backset, so a body can be matched to an existing rebate before anything is ordered. Multi-point bodies carry the locking points; single-point bodies are used where one locking point plus the rod set is enough; passage bodies latch without locking.
Handle hole spacing is printed as 85 / 92 mm on the bodies on this page, which covers the usual lever sets.
- Faceplate
- 14.8 mm wide, 2.5 mm edge, on the bodies on this page
- Backset
- 35–50 mm across the models listed
- Handle centres
- 85 / 92 mm
- Types
- Multi-point, single-point and passage bodies
Representative models
Catalogue numbers are kept exactly as printed, so a number used before is the same part now.
| Model | Type | Faceplate length (mm) | Backset (mm) | Handle centres / note |
|---|---|---|---|---|
| OHL.ST-29 | Multi-point lock body | 340 | 42 | 85 / 92 mm centres |
| OHL.ST-34 | Multi-point lock body | 340 | 47 | 85 / 92 mm centres |
| OHL.ST-20 | Single-point lock body | 210 | 35 | 85 / 92 mm centres |
| OHL.ST-25 | Single-point lock body | 210 | 40 | 85 / 92 mm centres |
| OHL.ST-35 | Single-point lock body | 210 | 50 | 85 / 92 mm centres |
| OHL.ST-217 | Passage lock body | In the catalogue drawing | In the catalogue drawing | Latch without lock |
| OHL.ST-218 | Passage lock body | In the catalogue drawing | In the catalogue drawing | Latch without lock |
| OHL.ST-219 | Passage lock body | In the catalogue drawing | In the catalogue drawing | Latch without lock |
Faceplate and backset are printed beside each drawing; the passage bodies are dimensioned on catalogue page 103 and those dimensions come with the model list rather than being restated here. Locking point spacing changes with sash height, so the body is chosen together with the rods and keepers.
Ask for the complete model list of this family: every model with the sizes, materials and finishes printed for it, plus the drawing for the ones you shortlist.
Before you order
Three things decide whether a part fits: the profile it is screwed to, the sash it has to carry, and the set it belongs to.
- Backset has to match the rebate of your profile; a 42 mm body will not fit a rebate made for 35 mm.
- The body is supplied with the transmission rods and keepers as one set, so the locking points line up with the rod positions.
- Locking point count follows sash height; the numbers for your sash size are in the selection table sent with the quote.
Ask for the complete model list
Send the profile groove, the sash size and the model numbers you already use. We reply with the same numbers, the dimensions for your sash and the price of the set.